Dräger X-pid^® 9500

• ​​Selective VOC gas detection
• For frequent testing of toxic & carcinogenic substances
• Laboratory quality results in very low concentrations
• Benzene measurement starting from 50 ...

Dräger X-am^® 8000

• ​1- to 7 gas detection device
• for clearance measurement
• detection of toxic and combustible gases as well as vapors and oxygen

PID sensors

PID sensors are the ideal choice for detecting low concentrations of volatile organic compounds. A PID (photoionization detector) is used to measure hazardous substance groups or can even be adjusted to measure ...

Dräger Sampling Tubes and Systems

• ​analysis of the sample in a laboratory
• measurement of complex compounds and mixtures of substances possible 
• detection of low concentrations possible 

Dräger-Tubes^® for short-term measurements

• ​results are directly shown at the end of the measurement process
• spot measurement for more than 500 different gases 
• short measurement time: between 5 seconds to 15 minutes

Dräger X-act^® 7000

• ​Precise gas measurment in the lower ppb range
  
• Based on colorimetric chemical sensor technology
  
• All calibration information on the RFID
  
• Benzene measurement starting ...

Dräger accuro

• for spot measurements with a limited number of strokes
  
• integrated stroke counter for safe control
• easy to operate with one hand
• can be used in explosive areas 

Dräger X-plore^® Bayonet Filter

• Dräger specific Bayonet connection
• lateral position of the filters for an unrestricted field of vision and even weight distribution
• to be used with X-plore 3300 or X-plore 3500 half ...

Dräger X-plore^® Rd40 Filter

• ​standard thread connection Rd40 (40mm)
• robust aluminium housing
• to be used with full face masks with standard thread connection Rd40 (40mm)

Dräger Panorama Nova^®

• ​​different thread connections: RA thread connection Rd40, PE thread connection M45x3, ESA plug-in connector, P Dräger plug-in connection
• EPDM or silicone mask body, visor made of triplex or ...

Dräger X-plore^® 5500

• Dräger specific bayonet connection - lateral position of the filters 
• EPDM mask body, visor made of triplex or PC
• to be used in combination with X-plore Bayonet filters​

Dräger X-plore^® 6300

• ​standard thread connection Rd40 according to EN 148-1
• EPDM mask body, visor made of PMMA
• to be used with all filters with standard thread connection Rd40

Dräger X-plore^® 6530

• ​standard thread connection Rd40 according to EN 148-1
• EPDM mask body, visor made of triplex or PC
• to be used with all filters with standard thread connection Rd40

Dräger X-plore^® 3300/3500

• ​Dräger specific bayonet connection (twin-filter system)
• mask body made from Soft-TPE or DrägerFlex material (silicon free)
• to be used with X-plore Bayonet filters

Dräger X-plore^® 8000

Workplace environments that compromise the quality of air you breathe demand reliable solutions. The Dräger X-plore 8000 PAPR offers a new level of intuitive handling combined with intelligent electronics. The result? ...

Dräger X-plore^® 8000 Filters

• Particle, gas and combination filters available
• To be used with powered air purifying respirator X-plore^® 8500 or 8700 (EX)
• Optional pre- and odour filter

Dräger CPS 5900

• ​SCBA worn inside the protective suit
• five suit sizes (S-XXL)
• side zipper
• suit material Zytron^® 500, limited use 

SPC 4700 with CVA 0700

​Comfort and mobility, along with optimal protection: that's what you get when you combine the Dräger SPC 4700 liquid-tight protective suit with the CVA 0700 ventilation vest. This type 3 suit reliably protects ...