Refrigerant Transmitter
- Detects refrigerant gas leaks using infrared technology
- Monitors occupational exposure limits in the ppm range
Focus on safety: Monitor your cooling system reliably for leaks
Quick Links
Accessories
Downloads
Contact us
Highlights
Reliably detect refrigerant gas leaks with the infrared sensor based Dräger Refrigerant Transmitter. Safely monitor occupational exposure limits for specific refrigerants with detection levels as low as 10 ppm. Transmits a 4–20 mA signal to the control system of your choice. Also available in a serial bus version for integration with a Dräger VarioGard system.
Increased safety, cost reduction and climate protection
Cooling systems are used today in almost every area of logistics and industry. As it is technically almost impossible to hermetically seal them, up to 30% of the refrigerant charge is released into the environment every year. Gas detection systems f … More Information
rom Dräger make it possible to detect even the smallest leaks at an early stage and initiate corrective measures. This increases the safety of your system, reduces operating costs for refrigerants and electrical energy as well as making a significant contribution to climate protection.Comply with ASHRAE 15 Safety Standard for Refrigeration Systems
ASHRAE 15 requires the use of a refrigerant detection system in all machine rooms and in most cold rooms. Detectors need to trigger visual and audible alarms inside the rooms and outside of each entrance and actuate mechanical ventilation to reduce … More Information
the gas concentration below TLV-TWA toxicity levels.Fast and reliable refrigerant detection
Equipped with non-dispersive infrared technology (NDIR), the refrigerant transmitter quickly and reliably detects refrigerant even in the ppm range in ambient air. The optical measuring technology works according to a physical measuring principle – … More Information
without chemical reactions or wearing parts. This measuring stability gives you security in the operation of your refrigeration system. It also reduces the cost of verification and recalibration.High accuracy in occupational exposure limits
The infrared sensor measures refrigerant in the ppm range so the transmitter can detect a leak in time. It also makes it easier for you to comply with occupational exposure limits. Connect the refrigerant transmitter via an analogue or digital inter … More Information
face with a Dräger control unit to a gas warning system. This warns you early on exceeding the preset alarm values.Fast installation and easy handling
The compact and IP54 protected detector is easy to install with only four screws and one cable entry. The design of the gas inlet allows rapid gas exchange for a short response time. You can also fix the calibration adapter on it in order to check a … More Information
nd calibrate the transmitter with little effort. The settings on the device are made via push buttons in the front panel. LEDs give the user visual feedback about the respective device status and helps you navigate through the menu.Broadband – Measure multiple gases simultaneously
With the broadband refrigerant transmitter, multiple gases can be measured in one setup. This is factory calibrated to 2000 ppm R134a, but is also ideal for measuring R125, R404a, R407a, R410a, R448a, R449a and R407f. Using simple conversion factors … More Information
, which are stored in the software of the gas detector, the measured values can thus be corrected for an accurate measurement.
Next Steps
Get in touch with Dräger—
